Jump to content

07NOV20 | WorldFlight Inbound


Joshua M - 1342084
 Share

Recommended Posts

Clean_Banner_WF_ARR.png

It is once again that time of the year!

 

VATPAC invites you to join the Inbound Leg of WorldFlight 2020, a week long event travelling around the world raising funds for the Royal Flying Doctor Service (RFDS). Aircraft will depart Sydney on the 1st at 8:00am AEDT (2100z) and arrive a week later on the 7th at 8:35pm AEDT (0935z). With full ATC along the way, all VATSIM members are invited along to join in from home. 

For more information on WorldFlight or to make a donation, please head to the WorldFlight website

 

Pilot & Controller Information:
Documentation for both Pilots and Controller will be released for WorldFlight Outbound and Inbound Legs within VATPAC Airspace. This document will cover all information required by Pilots and Controllers when operating each WorldFlight Leg within VATPAC Airspace. Watch this space and find it below when it is released on Friday 30th October 2020

 

ATC Applications:
Applications for the Inbound Leg are now open! Apply below!

https://events.vatpac.org/worldflight-2020-inbound

 

Scenery:
AYPY - Port Moresby
Payware - ORBX (FSX/P3D)
Freeware - AVSIM (FSX)
Freeware - xPlane

YBCS - Cairns Airport
Payware - ORBX (FSX/P3D)
Freeware - AVSIM (FSX/P3D)
Freeware - FSClips (xPlane)

YBBN - Brisbane International Airport:
Payware - ORBX (FSX/P3D)
Freeware - AVSIM (FSX/P3D)

YSSY - Sydney International Airport:
Payware - FlyTampa v2 (FSX/P3D)
Freeware - AVSIM (FSX/P3D)
Freeware - ISDG (xPlane)

Link to comment
Share on other sites

  • 2 weeks later...

WF_Feedback.thumb.png.a17d4567acd90f94f110f7d5628325b2.png

Good Morning Everyone!

At the conclusion of WorldFlight, VATPAC is looking to gain feedback about how we as a Division went in the organization of this event - The survey will only take 2-3 minutes to complete

Please fill out the following survey.

We ask that you be sincere in your feedback to assist us in improving this event in the future.

Thanks, everyone!

Link to comment
Share on other sites

 Share

×
×
  • Create New...